Power Catamaran Project

Sale of Power Catamaran Project (2019)

Due to health issues, we are selling our Power Catamaran project started in 2019.

Specifications:

• Width: 4.60 m
• Length: 11.99 m

Technical Details:

• The hull, ribs, and frames of our boat are made of “Eucalyptus” wood.
• The hull covering is laminated with 8mm and 10mm Beech Marine Plywood with epoxy resin (3-4 layers) and covered with fiberglass fabric (3-4 layers).
• The sides and lower hull are puttied with Polisan Marine Epoxy Putty and sanded.
• The deck, roof, and wet areas are additionally coated with Duraflex Tolerance Primer. The salon is coated from the outside.
• The keels and hulls of the boat are joined with double-sided steel profiles, the mooring areas are reinforced with profiles, and anti-rust treatment has been applied to the profiles. Sail preparation (mast socket) is done; a sail mast can be installed optionally.
• Water, waste water, and fuel tanks to be placed inside the hulls are made (8 units – approximately 160 liters), molds are available. Independent compartments against collisions and injuries are made at the front and rear ends to prevent the boat from sinking.
• 2 Universal 30Hp engines have been purchased (maintenance not yet done, engines are documented).
• Our plan was to build a hybrid-electric catamaran, so there is enough space in the engine room and hulls. Solar panels can be installed on the top.
• Additionally, 2 Fiber Paddleboards and molds for Fiber casting are available.

Additional Information:

• Photos of all stages are available.
• It can be easily prepared for the summer season.

Make an Offer now

Your Message